Connect the blue cable that came with the modem from your computer into the modem
You can do this by plugging the serial plug into the serial jack in the back of your computer and the RJ45 plug (the one that looks like a wide phone plug) in to the back of the modem - in the jack labeled MGMT.
Open Hyperterminal
[typically the path to the hyperterminal application is
Start -> Programs -> Accessories -> Communications -> Hyperterminal]
Name the new session: new session
In the windows that follow type following entries
Connect via COM1
Click 'OK'
Use the following settings for communication to the modem:
Bits per second: 9600
Data bits: 8
Parity: none
Flow Control: none
wait
You will have to type "en" to enable the modem -- then hit [RETURN]
at user and pass
for example
cbos>en [RETURN]
Hit [Return] twice
"cbos#" is the prompt the modem will give you. You then enter the
following
entries after the #:
ccbos# set nvram erase[RETURN]
cbos# write[RETURN]
cbos# reboot[RETURN]
cbos# set bridging rfc1483 enabled[RETURN]
cbos# write[RETURN]
cbos# set bridging management enabled[RETURN]
cbos# write[RETURN]
cbos# reboot[RETURN]
The IP address of your computer connected to this DSL modem should be.
64.146.133.xxx[your saw.net support technician will give you this number]
255.255.255.0 subnet mask
64.146.133.1 default gateway
