Connect the blue cable that came with the modem from your computer into the modem.
You can do this by plugging into the serial plug into the serial jack in the back of your computer and the RJ45 plug (the one that looks like a wide phone-plug) into the back of the modem - into the jack labeled MGMT
Open Hyperterminal
[typically the path to the hyperterminal application is
Start -> Programs -> Accessories -> Communications -> Hyperterminal]
Name the new session: new session
In the windows that follow, type the following entries:
Connect via COM1
Click 'OK'
Use the following settings for communication to the modem:
Bits per second: 9600
Data bits: 8
Parity: none
Flow Control: none
wait
You will have to type "en" to enable the modem -- [RETURN]
at user and pass
cbos>en [RETURN]
Hit [RETURN] twice
"cbos#" is the prompt the modem will give you. You then type the
following entries after the #:
cbos# set bridging rfc1483 enabled [RETURN]
cbos# write [RETURN]
cbos# reboot [RETURN]
cbos# set int wan0-0 close [RETURN]
cbos# set int wan0-0 vpi 0 [RETURN]
cbos# set int wan0-0 vci 32 [RETURN]
cbos# set int wan0-0 open [RETURN]
cbos# write [RETURN]
cbos# reboot [RETURN]
The IP address of your computer connected to this DSL modem should be.
64.146.133.xxx[your saw.net support technician will give you this number]
255.255.255.0 subnet mask
64.146.133.1 default gateway
